Telos NX12 User Manual Page 15
- Page / 133
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
| 5
2
Installation
2.1 Getting Started
e Nx12 mounts in a 2RU high space in a standard 19” rack. You do not need to pay special
attention to cooling or ventilation, as the unit will operate in any environment where the stirred
air temperature around the unit is between 0 to 40 degrees Celsius (32 to 104 degrees Fahren-
heit) with a relative humidly of 0 to 98% (non-condensing).
Next installation steps are:
Connect the Telco circuits. Learn about telephone service options.
♦
Connect audio, via either analog, AES3, or Livewire. Learn about mix-minus. ♦
Connect your Desktop Directors. ♦
If needed, connect a PC for Web user interface, either directly or via a LAN (local area ♦
network). You can use the front-panel LCD/button interface for most operations, but you
will need the Web interface for ISDN and Livewire configuration. And you will need the
LAN connection if Telos Assistant Producer or other call screening software is to be used.
Connect any needed parallel GPIO. ♦
is Installation section covers all of the above. After completing these steps, you will be ready
to move on to configuration and testing.
2.2 Connections to the Telco circuits
e Nx12 has two slots for Telco interface modules, each supporting up to 6 lines. Any combi-
nation of POTS or ISDN line cards can be used.
If your Nx12 will be “behind” a PBX (private telephone system), see Section 2.6 for more on
this integration.
IMPORTANT
Being a broadcast station, you will probably have high call volume. If your PBX has a PRI or
T-1 coming from the phone company that will be shared for business operations, it may need
to be programmed to reserve some capacity for those calls. One option would be to have
the Telco provision (congure) the PRI or T-1 into separate trunk groups for the Business and
On-air telephone numbers. You should discuss this with both your local telephone service
provider and your PBX provider. You should also inform your Telco that this will be a high
volume application so they can be sure that your contests will not interfere with 911 and
other emergency services.
- TELOS Nx12 1
- We support you 2
- Notices and Cautions 3
- CAUTION: 3
- WARNING: 3
- Table of Contents 5
- Introduction 11
- 2 12
- INTRODUCTION 13
- Installation 15
- 2.4 ISDN Technology 101 16
- Data and Voice 17
- Hunt Groups 17
- Ordering Help 18
- INSTALLATION 19
- 2.6 Integration with a PBX 20
- 2.7 Studio Audio Connections 21
- 12 22
- Using a small mixer 23
- Phones and Remotes 23
- Input (To Caller ) 24
- INSTALLATION 25
- Output (Caller) 26
- 2.8 Desktop Director Ports 27
- 18 28
- Connecting Desktop Directors 29
- 20 30
- 2.9 Ethernet 31
- 22 32
- INSTALLATION 33
- 2.11 AC (mains) Power 34
- Basic Conguration 35
- Analog Phone Line Setup 36
- ISDN Setup 36
- BASIC CONFIGURATION 37
- Is the ISDN working? 38
- 3.3 Audio Input and Output 39
- Time to test it out! 40
- What now? 41
- User Operation 43
- 34 44
- Call is on the handset 44
- Call is on the speakerphone 44
- Line Button Columns 45
- Hold & Drop 45
- Block All 46
- Dialing Keypad 46
- Function Buttons 46
- USER OPERATION 47
- 38 48
- USER OPERATION 49
- [Producer] if 49
- 40 50
- [Talent] if you 50
- USER OPERATION 51
- 4.2 The Call Controller 52
- 4.3 The Console Director 52
- 5.1 Level Metering 53
- 5.2 Status Displays 54
- Desktop Director Status 55
- The LCD/Button User Interface 56
- The Web User Interface 56
- 5.4 The Audio Menu 57
- Nominal Output Level 58
- Meter Mode 58
- Phone Send Adjustment 58
- Call Ducking 59
- Receive AGC 59
- Noise Gate 59
- Feedback Reduction 60
- Mix Minus Mode 60
- 52 62
- AES Mode 63
- 5.5 The Telco Menu 64
- ISDN Protocol 65
- 56 66
- SPIDs and MSN/DNs (Web Only) 67
- 58 68
- 5.6 The System Menu 69
- Contrast (LCD Only) 70
- Show Mode (LCD Only) 70
- Hold on Select 71
- Audio Loop (LCD Only) 71
- Factory Defaults (LCD Only) 71
- Reboot (LCD Only) 71
- 5.7 Show Modes 72
- 64 74
- 5.8 Livewire 75
- 66 76
- Quality of Service 77
- Axia Consoles 77
- 5.9 Firmware Update 78
- Logged in with user rights 79
- >>? CPC <return> 80
- Send Audio Processing 81
- 72 82
- 74 84
- 6.1 Overview 85
- 6.3 General Troubleshooting 85
- 76 86
- 78 88
- 80 90
- CLASS 1.1 (normal) 92
- 84 94
- 86 96
- 88 98
- 90 100
- Specications 101
- Audio Performance 102
- Desktop Director Ports 103
- Control Ports 103
- Two-Studio Modes 103
- Four-Column/Four-Hybrid Mode 104
- “Euro” Operation Mode 104
- SPECIFICATIONS 105
- 107
- USA SPIDs by Telco 109
- 100 110
- USA SPIDS BY TELCO 111
- Telephone Terminology Guide 113
- 104 114
- 106 116
- 108 118
- 110 120
- 112 122
- 114 124
- USA ISDN Ordering Guide 125
- 116 126
- (ISDN Order Code Capability) 127
- ISDN BRI LINE ORDER 128
- □ No hunt groups 129
- 120 130
- Euro-ISDN Ordering Guide 131
- 122 132
© 2020, manymanuals.com. All rights reserved. | 0.202 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals