Telos NX12 User Manual Page 48
- Page / 133
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
38 | Section 4
Adjust Volume
Ringer 5
Speaker 5
Handset 5
back [-] [+]
Press ∆ or ∇ to choose which level you want to adjust. Pressing [-] will decrease, while pressing
[+] will increase the volume level for the item displayed. e change will take place immediately.
Pressing the soft key button under the word back or the Select button will return you to the
main screen. e following volume levels can each be individually adjusted:
Ringer
♦ – Adjusts the volume of the ringer. Note that the ringer will usually be turned off
whenever a microphone channel is on.
Speaker
♦ – Adjusts the level of the Desktop Director’s loudspeaker.
Handset
♦ – Sets the level of the caller on the handset. If you are using a headset attached
to the Desktop Director, this will adjust the level in the headset as well.
Other Menu options
After selecting menu from the main LCD screen, the following are offered:
Select Ringer ♦ – It is possible to change the ringer tone on each Desktop director. ere
are four different choices. Press Select to apply your changes.
Configure Shows
♦ – is gives access to the programing functions for two-studio modes,
where each pair of hybrids is assigned to one of two studios. See Section 5.6.
Adjust LCD Panel
♦ – Gives access to the same menu as the LCD button on the main
screen.
Diagnostics
♦ – is gives a status report of the connection between the Desktop Director
and the Nx12 unit to which it is connected. Two values are reported:
Near End: the number of lost or corrupted data packets in the Nx12 to Desktop
♦
Director direction since this Director was powered on.
Far End: the number of lost or corrupted data packets in the Desktop Director to
♦
Nx12 direction since this Director was powered on.
Version
♦ – Reports the currently running Nx12 software version number and the currently
running Desktop Director software version number.
About
♦ – General information.
Changing Between Producer and Talent Modes
A Desktop Director can be in either Producer or Talent mode. is can be changed at any time
independently for each Director in the system. Producer mode can be thought of as ‘screener
phone’ mode while Talent mode can be thought of as ‘on-air’ mode. To change between Pro-
ducer and Talent modes:
On the main screen, press the soft key button below the word 1. Menu. You should now see
a screen that looks similar to the following:
- TELOS Nx12 1
- We support you 2
- Notices and Cautions 3
- CAUTION: 3
- WARNING: 3
- Table of Contents 5
- Introduction 11
- 2 12
- INTRODUCTION 13
- Installation 15
- 2.4 ISDN Technology 101 16
- Data and Voice 17
- Hunt Groups 17
- Ordering Help 18
- INSTALLATION 19
- 2.6 Integration with a PBX 20
- 2.7 Studio Audio Connections 21
- 12 22
- Using a small mixer 23
- Phones and Remotes 23
- Input (To Caller ) 24
- INSTALLATION 25
- Output (Caller) 26
- 2.8 Desktop Director Ports 27
- 18 28
- Connecting Desktop Directors 29
- 20 30
- 2.9 Ethernet 31
- 22 32
- INSTALLATION 33
- 2.11 AC (mains) Power 34
- Basic Conguration 35
- Analog Phone Line Setup 36
- ISDN Setup 36
- BASIC CONFIGURATION 37
- Is the ISDN working? 38
- 3.3 Audio Input and Output 39
- Time to test it out! 40
- What now? 41
- User Operation 43
- 34 44
- Call is on the handset 44
- Call is on the speakerphone 44
- Line Button Columns 45
- Hold & Drop 45
- Block All 46
- Dialing Keypad 46
- Function Buttons 46
- USER OPERATION 47
- 38 48
- USER OPERATION 49
- [Producer] if 49
- 40 50
- [Talent] if you 50
- USER OPERATION 51
- 4.2 The Call Controller 52
- 4.3 The Console Director 52
- 5.1 Level Metering 53
- 5.2 Status Displays 54
- Desktop Director Status 55
- The LCD/Button User Interface 56
- The Web User Interface 56
- 5.4 The Audio Menu 57
- Nominal Output Level 58
- Meter Mode 58
- Phone Send Adjustment 58
- Call Ducking 59
- Receive AGC 59
- Noise Gate 59
- Feedback Reduction 60
- Mix Minus Mode 60
- 52 62
- AES Mode 63
- 5.5 The Telco Menu 64
- ISDN Protocol 65
- 56 66
- SPIDs and MSN/DNs (Web Only) 67
- 58 68
- 5.6 The System Menu 69
- Contrast (LCD Only) 70
- Show Mode (LCD Only) 70
- Hold on Select 71
- Audio Loop (LCD Only) 71
- Factory Defaults (LCD Only) 71
- Reboot (LCD Only) 71
- 5.7 Show Modes 72
- 64 74
- 5.8 Livewire 75
- 66 76
- Quality of Service 77
- Axia Consoles 77
- 5.9 Firmware Update 78
- Logged in with user rights 79
- >>? CPC <return> 80
- Send Audio Processing 81
- 72 82
- 74 84
- 6.1 Overview 85
- 6.3 General Troubleshooting 85
- 76 86
- 78 88
- 80 90
- CLASS 1.1 (normal) 92
- 84 94
- 86 96
- 88 98
- 90 100
- Specications 101
- Audio Performance 102
- Desktop Director Ports 103
- Control Ports 103
- Two-Studio Modes 103
- Four-Column/Four-Hybrid Mode 104
- “Euro” Operation Mode 104
- SPECIFICATIONS 105
- 107
- USA SPIDs by Telco 109
- 100 110
- USA SPIDS BY TELCO 111
- Telephone Terminology Guide 113
- 104 114
- 106 116
- 108 118
- 110 120
- 112 122
- 114 124
- USA ISDN Ordering Guide 125
- 116 126
- (ISDN Order Code Capability) 127
- ISDN BRI LINE ORDER 128
- □ No hunt groups 129
- 120 130
- Euro-ISDN Ordering Guide 131
- 122 132
© 2020, manymanuals.com. All rights reserved. | 0.940 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals