Telos NX12 User Manual download pdf (Page 74)

64 | Section 5

SHOW 2 ♦ – Line is available for the show that uses hybrid 2 only

SHOW 1&2

♦ – Line is available for both shows (shared line)

Press the SELECT button to accept your changes.6.

Note: You must reboot the system after conﬁguring this setting. If you wish to conﬁgure lines as

‘Priority’ or ‘Normal’ (see below) you may do so before rebooting.

To conﬁgure lines as Priority or Normal lines:

Press the MENU softkey.1.

Press <2. ∇> repeatedly until Conﬁgure Shows is highlighted and then press <SELECT>.

Enter the password and then press the OK softkey. NOTE: e default password is 1234.3.

Press <4. ∇> repeatedly to highlight Set Priority Lines and then press <SELECT>.

Use <5. ∇> and <∆> to highlight each line. For each line, use the <+> or <-> Softkeys to

select from the following options:

Normal

♦ – Line is included in the block-all group

Priority

♦ – Line is excluded from the block-all group. If this line is ringing, the Prior-

ity Ring Output (pin 2) on the parallel control port will go true.

Press the SELECT button to accept your changes.6.

Note: You must reboot the system after conﬁguring this setting. Be sure to attach the phone

lines before rebooting.

To change the password:

Press the MENU softkey1.

Press <2. ∇> repeatedly until Conﬁgure Shows is highlighted and then press <SELECT>.

Enter the password and then press the OK softkey. 3. Note: e default password is 1234.

Press <4. ∇> repeatedly to highlight Change Password and then press <SELECT>.

Enter a 4 digit password. Press each digit carefully. en press the OK softkey. If you are 5.

uncertain if you have entered the desired password, press the BACK softkey instead of

OK.

Press the BACK softkey repeatedly until back to the main menu.6.

Note: Restore Factory Defaults will restore the original password, but it will also erase all other

settings.

Selecting a Show on the Desktop Director and other controllers

In the two-studio modes, each Desktop Director or other controller must select a Show.

Selecting a Show using a Desktop Director

To do so, follow these steps:

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 132 133

No comments

Telos NX12 User Manual Page 74