Telos NX12 User Manual download pdf (Page 80)

70 | Section 5

Type ‘help <command>’ to get specic help about a command.

Type ‘help *’ to get a short list of commands.

Type ‘help **’ to get a detailed list of commands.

Type ‘help <chars>*’ to get a list of commands starting with

<chars>.

‘#’ starts a decimal number, ‘%’ a binary number, ‘$’ a hex number.

Current number base is 16.

Separate multiple commands on a line by ‘::’.

List of available commands:

? CPC acc autoans bootstat bye call cidalert csinfo daa daacheck dd

disc

dmr dmw droponcptd fpkey gpio

help hookash hybrid isdn isdnlog lawmode lcgood lcignore lcinfo

lcoffset

lcwait lines log login logon lw

mcheck meter minonhook mixpoll mr mw potscountry prio quit reboot

ringtimo

test ti tslot

For a description of a command, type ‘help’ or ‘?’ followed by the name of a command. Example:

>>? CPC <return>

Command....: CPC <time in msec>

Description: Specify the time in msec a loop current drop must last

before a far-end drop is recognized. When set to 0 then loop cur-

rent drops are not detected at all.

A particularly useful command is for ISDN logging. is turns the Nx12 into an ISDN proto-

col analyzer so you can see the communications between the Nx12 and the Telco network.

>>? Isdnlog <return>

? isdnlog

Command....: isdnlog <bitmask>

Description: Specify ISDN logging mode bitmask: b0=general logging,

b1=Layer2, b3=layer3 b4=IIEs, b5=raw packet, b6=Telesoft stack.

Usually, 0xF is a good choice.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 132 133

No comments

Telos NX12 User Manual Page 80